The short version of melanocortin analogue fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-03-26 and is reviewed periodically as new material appears.
Bremelanotide is a synthetic cyclic heptapeptide developed as an analogue of alpha-melanocyte-stimulating hormone, a naturally occurring peptide involved in pigmentation and appetite signalling. Its structure contains seven amino acid residues joined by a lactam bridge that closes the ring between two side chains. The molecular formula is C50H68N14O10 and the nominal molecular mass is near 1025 daltons. Much of the early laboratory literature refers to the same molecule by the development code PT-141.
The compound emerged from a research programme examining melanocortin analogues for effects on skin pigmentation. During early human studies, participants reported spontaneous erections as an unexpected side effect, which redirected development toward sexual function rather than tanning. An intranasal formulation was investigated in clinical trials but did not reach market approval. A subcutaneous injectable version later completed the regulatory process, and the nasal route does not appear in approved labelling.
Approved use is narrow and jurisdiction-specific. In the United States, the injectable product is authorised for premenopausal women with acquired, generalised hypoactive sexual desire disorder, a diagnosis that requires documented distress. It is not approved for men, for postmenopausal women, or for use alongside hormonal contraceptives under the approved labelling. Outside regulated markets, the same peptide is frequently sold as a research chemical, where identity, purity, and sterility are not independently verified.
Identity and purity are usually established with reversed-phase high-performance liquid chromatography combined with mass spectrometry. A gradient of water and acetonitrile containing trifluoroacetic acid is a common mobile phase, and ultraviolet detection near 214 nanometres responds to the peptide backbone. Mass spectrometry confirms the expected molecular mass and helps reveal truncation or oxidation products. Purity is reported as a peak-area percentage, a figure that depends on the wavelength and gradient used, so values from different laboratories are not always directly comparable. Peptide mapping and amino acid analysis provide additional confirmation when required.
Regulatory status varies by jurisdiction, where approved prescription products, compounded preparations and research-grade material are treated as distinct categories with different documentation requirements. Suppliers of research material commonly issue a certificate of analysis listing purity, identity and sometimes endotoxin content. Independent verification by a third-party laboratory is often recommended because self-reported figures are difficult to check. Literature discussions usually state the source, purity and storage conditions of the material used, since these details affect reproducibility. Analysts note that a reported purity figure does not by itself describe biological activity.
Lyophilised peptide is generally held below minus twenty degrees Celsius, protected from light and moisture, because hydrolysis and oxidation accumulate faster at ambient temperature. Once reconstituted, solutions are typically kept between two and eight degrees Celsius and used within a short window defined by the supplier. Repeated freeze-thaw cycles are avoided since they promote aggregation and loss of soluble material. Container material matters as well, because peptides adsorb to certain plastics and glass surfaces at low concentration. Stability figures supplied by a vendor apply only to the specific lot and buffer that were tested.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C50H68N14O10 | Cyclic heptapeptide backbone |
| Molecular mass | Approximately 1025 Da | Nominal mass of the free peptide |
| Appearance | White to off-white lyophilised powder | Typical for purified synthetic peptides |
| Solubility class | Freely soluble in water | Organic solubility is limited |
| Typical storage temperature | −20 °C or below | Protect from moisture and light |
PT-141 is the research code for bremelanotide, a cyclic heptapeptide derived from alpha-melanocyte-stimulating hormone. The molecule belongs to the melanocortin receptor agonist family and shows highest affinity for the MC4 receptor subtype, with weaker activity at MC1, MC3 and MC5. Its structure retains the core His-Phe-Arg-Trp sequence that defines melanocortin recognition, while cyclization and terminal modifications improve metabolic stability relative to the parent hormone. Early work classified the compound as a centrally acting agent rather than a peripherally acting vasodilator, which shaped subsequent development priorities.
Receptor activation in hypothalamic and limbic circuits is the mechanism most often cited for the observed effects on sexual desire. Signalling through MC4R couples to Gs proteins and raises intracellular cyclic AMP, which in turn modulates dopaminergic tone in reward-related pathways. Because the peptide reaches the central nervous system after subcutaneous administration, peripheral vascular changes are regarded as secondary rather than primary. The precise neural circuits that translate receptor occupancy into behavioural change remain incompletely mapped, and published accounts describe the pathway in general terms rather than as a fully resolved sequence.
Development began with intranasal formulations investigated for erectile dysfunction, but blood pressure elevation limited that route and prompted a switch to subcutaneous delivery. Clinical testing then shifted toward hypoactive sexual desire disorder in premenopausal women, and a subcutaneous product received United States approval in 2019. Later trials examined other populations with mixed results, and questions about effect size, durability and patient selection remain open in the peer-reviewed literature. Research interest continues in parallel with the broader melanocortin field, where several synthetic analogues are studied together.
The compound binds several melanocortin receptor subtypes rather than a single target, with the strongest functional activity reported at MC4R and measurable activity at MC1R, MC3R and MC5R. MC4R populations are dense in hypothalamic nuclei that integrate energy balance, autonomic tone and reproductive behaviour, which is the anatomical basis for the proposed pro-desire effect. Because binding is not subtype-selective, pigmentary and vascular effects accompany central activity. Improving subtype selectivity is an active area of analogue design. Direct causal mapping from receptor occupancy to reported desire change in humans is not fully established.
After subcutaneous dosing, peak plasma concentrations appear within roughly one hour, and elimination is fast, with a half-life on the order of a few hours. Degradation is mainly proteolytic, and at least one circulating fragment retains receptor activity, so parent-drug levels alone do not describe total exposure. Clearance does not depend heavily on hepatic cytochrome enzymes, which lowers the likelihood of common metabolic interaction routes. Data in renal or hepatic impairment are limited. Repeated dosing does not appear to produce marked accumulation given the short half-life.
Reported pharmacodynamic effects include transient rises in blood pressure and heart rate, flushing, nausea and headache, appearing soon after dosing and resolving within hours. These responses were dose-related in early studies and shaped the label's cardiovascular cautions and blood pressure monitoring advice. Gastrointestinal upset is the most frequent reason cited for discontinuation in trials. Whether the vascular signal attenuates with repeated use is not settled. Central effects on desire are described as emerging over weeks rather than immediately, which points to a cumulative rather than acute process.
Bisulfite treated DNA is then PCR amplified, resulting in cytosine residues at originally methylated positions, and thymine residues at originally unmethylated position (that were converted to uracil). Primers used during this step do not contain CpG sites (the common target of cytosine methylation), so the amplification process does not discriminate between templates based on methylation status. PCR products are purified to ensure complete digestion in the following step.
== Carbohydrate Consumption == Humans can consume a variety of carbohydrates, digestion breaks down complex carbohydrates into simple monomers (monosaccharides): glucose, fructose, mannose and galactose. After resorption in the gut, the monosaccharides are transported, through the portal vein, to the liver, where all non-glucose monosacharids (fructose, galactose) are transformed into glucose as well. Glucose (blood sugar) is distributed to cells in the tissues, where it is broken down via cellular respiration, or stored as glycogen. In cellular (aerobic) respiration, glucose and oxygen are metabolized to release energy, with carbon dioxide and water as endproducts.
This stirred up a wave of protest among the Catholic population, and bishops, Catholic organisations and the Centre Party itself united to combat the "red danger". This conflict bridged internal tensions within the party and secured its continual existence despite the turmoil of the revolution. The party however was weakened by its Bavarian wing splitting off and forming the Bavarian People's Party (BVP), which emphasised autonomy of the states and also took a more conservative course. In the 1919 elections for the Weimar National Assembly, the Centre Party gained 91 representatives, being the second largest party after the Social Democratic Party (SPD). The Centre's Constantin Fehrenbach was elected president of the National Assembly. The party actively cooperated with Social Democrats and left-liberal German Democratic Party (DDP) in drawing up the Weimar Constitution, which guaranteed what the Centre had been fighting for since its founding: equality for Catholics and autonomy for Catholic Church throughout Germany. The party was less successful in the school question. Although religious education remained an ordinary subject in most schools, the comprehensive, inter-denominational schools became default.
To study the double-shell system, after synthesis of the core CdSe nanocrystals, a layer of ZnSe was coated prior to the ZnS outer shell, leading to an improvement in fluorescent efficiency by 70%. Furthermore, the two additional layers were found to improve resistance of the nanocrystals against photo-oxidation, which can contribute to degradation of the emission spectra. It is also standard for surface passivation techniques to be applied to these core/double-shell systems, as well. As mentioned above, oleic acid is one such organic capping ligand that is used to promote colloidal stability and control nanocrystal growth, and can even be used to initiate a second round of ligand exchange and surface functionalization. However, because of the detrimental effect organic ligands have on PL efficiency, further studies have been conducted to obtain all-inorganic quantum dots. In one such study, intensely luminescent all-inorganic nanocrystals (ILANs) were synthesized via a ligand exchange process which substituted metal salts for the oleic acid ligands, and were found to have comparable photoluminescent quantum yields to that of existing red- and green-emitting quantum dots.
Sources: en.wikipedia.org
Many mixed valence compounds contain both iron(II) and iron(III) centers, such as magnetite and Prussian blue (Fe4[Fe(CN)6]3). The latter is used as the traditional "blue" in blueprints. Iron is the first of the transition metals that cannot reach its group oxidation state of +8, although its heavier congeners ruthenium and osmium can, with ruthenium having more difficulty than osmium. Ruthenium exhibits an aqueous cationic chemistry in its low oxidation states similar to that of iron, but osmium does not, favoring high oxidation states in which it forms anionic complexes. In the second half of the 3d transition series, vertical similarities down the groups compete with the horizontal similarities of iron with its neighbors cobalt and nickel in the periodic table, which are also ferromagnetic at room temperature and share similar chemistry. As such, iron, cobalt, and nickel are sometimes grouped together as the iron triad. Unlike many other metals, iron does not form amalgams with mercury. As a result, mercury is traded in standardized 76 pound flasks (34 kg) made of iron. Iron is by far the most reactive element in its group; it is pyrophoric when finely divided and dissolves easily in dilute acids, giving Fe2+. However, it does not react with concentrated nitric acid and other oxidizing acids due to the formation of an impervious oxide layer, which can nevertheless react with hydrochloric acid. High-purity iron, called electrolytic iron, is considered to be resistant to rust, due to its oxide layer.
The 1886 Jaffé reaction, in which creatinine is treated with an alkaline picrate solution to yield a red complex, is still the basis of most commonly used methods for measuring creatinine. This reaction is nonspecific and subject to interference from many noncreatinine chromogens, including acetone, acetoacetate, pyruvate, ascorbic acid, glucose, cephalosporins, barbiturates, and protein. It is also sensitive to pH and temperature changes. One or another of the many modifications designed to nullify these sources of error is used in most clinical laboratories today. For example, the recent kinetic-rate modification, which isolates the brief time interval during which only true creatinine contributes to total color formation, is the basis of the Astra modular system. More specific, non-Jaffé assays have also been developed. One of these, an automated dry-slide enzymatic method, measures ammonia generated when creatinine is hydrolyzed by creatinine iminohydrolase. Its simplicity, precision, and speed highly recommend it for routine use in the clinical laboratory. Only 5-fluorocytosine interferes significantly with the test. Creatinine must be determined in plasma or serum and not whole blood because erythrocytes contain considerable amounts of noncreatinine chromogens. To minimize the conversion of creatine to creatinine, specimens must be as fresh as possible and maintained at pH 7 during storage. The amount of urea produced varies with substrate delivery to the liver and the adequacy of liver function.
=== Signal transduction === GHRH binding to GHRHR results in increased GH production mainly by the cAMP-dependent pathway, but also by the phospholipase C pathway (IP3/DAG pathway), and other minor pathways. The cAMP-dependent pathway is initiated by the binding of GHRH to its receptor, causing receptor conformation that activates Gs alpha subunit of the closely associated G-Protein complex on the intracellular side. This results in stimulation of membrane-bound adenylyl cyclase and increased intracellular cyclic adenosine monophosphate (cAMP). cAMP binds to and activates the regulatory subunits of protein kinase A (PKA), allowing the free catalytic subunits to translocate to the nucleus and phosphorylate the transcription factor cAMP response element-binding protein (CREB). Phosphorylated CREB, together with its coactivators, p300 and CREB-binding protein (CBP) enhances the transcription of GH by binding to CREs cAMP-response elements in the promoter region of the GH gene. It also increases transcription of the GHRHR gene, providing positive feedback. In the phospholipase C pathway, GHRH stimulates phospholipase C (PLC) through the βγ-complex of heterotrimeric G-proteins. PLC activation produces both diacylglycerol (DAG) and inositol triphosphate (IP3), the latter leading to release of intracellular Ca2+ from the endoplasmic reticulum, increasing cytosolic Ca2+ concentration, resulting in vesicle fusion and release of secretory vesicles containing premade growth hormone.
Sources: en.wikipedia.org
It is a synthetic cyclic peptide that acts as an agonist at melanocortin receptors. It is not a hormone replacement therapy and not a vasodilator in the usual clinical sense, although it does affect vascular tone. Chemically it belongs to the melanocortin analogue family.
PT-141 was the internal development code used during early research and it persists in older publications, conference abstracts, and informal listings. The code and the approved name refer to the same molecule. Its continued use reflects habit in the literature rather than any difference in substance.
No. The intranasal form was studied in trials but was never approved, and absorption through the nasal route varies considerably between individuals. Approved labelling covers a subcutaneous injection only. Any nasal product sold outside regulated channels falls outside verified manufacturing.
Purity is normally expressed as a percentage of total peak area from a chromatographic run. The value depends on the column, gradient and detection wavelength chosen. Results generated under different conditions are therefore not always interchangeable.